Veranstaltungen/2009-12-04 ZFS-Workshop/Pool Scrubbing: Unterschied zwischen den Versionen

Aus UUGRN
(Navigation eingebaut\)
K (hat „ZFS-Workshop/Szenario: Pool Scrubbing“ nach „ZFS-Workshop/Pool Scrubbing“ verschoben: Kein Szenario)
(kein Unterschied)

Version vom 3. Dezember 2009, 17:14 Uhr

Aus der man-Page:

     zpool scrub [-s] pool ...

         Begins a scrub. The  scrub  examines  all  data  in  the
         specified  pools  to verify that it checksums correctly.
         For replicated (mirror or raidz) devices, ZFS  automati-
         cally  repairs  any  damage discovered during the scrub.
         The "zpool status" command reports the progress  of  the
         scrub  and summarizes the results of the scrub upon com-
         pletion.

         Scrubbing and resilvering are very  similar  operations.
         The  difference  is  that resilvering only examines data
         that ZFS knows to be out  of  date  (for  example,  when
         attaching  a  new  device  to  a  mirror or replacing an
         existing device), whereas scrubbing examines all data to
         discover  silent  errors  due to hardware faults or disk
         failure.

         Because  scrubbing  and  resilvering  are  I/O-intensive
         operations, ZFS only allows one at a time. If a scrub is
         already in progress,  the  "zpool  scrub"  command  ter-
         minates  it  and starts a new scrub. If a resilver is in
         progress, ZFS does not allow a scrub to be started until
         the resilver completes.

         -s    Stop scrubbing.

Scrub.png